Floor Sanding & Polishing in Bardon

The same $45–$90/m² range applies in Bardon as across Brisbane, and where a job lands depends almost entirely on board condition. Bardon’s older homes often sit mid-to-upper range once repairs are counted. The full tier breakdown is in our Floor Sanding Cost guide.

The character-home pockets around Bardon usually do. What’s under the carpet varies street to street — some floors need only a standard sand, others carry old stains, water marks or previous patch-ups that take extra passes and repair work. We price it honestly after seeing the boards, not before.

Very often, yes. Post-war and mid-century Bardon homes commonly hide solid hardwood — Spotted Gum, Blackbutt, Ironbark — under old carpet or vinyl. These floors usually restore beautifully and are tougher than most modern replacements.

Yes — we regularly work in units and apartments. We’ll help with the practical side too: body corporate notice, lift and access logistics, and low-odour water-based finishes that keep neighbours happy.

Yes. We colour and finish-match new sections to existing hoop pine, blackbutt, or spotted gum so repairs blend in.

Hoop Pine in the older Queenslanders and workers cottages, and Spotted Gum, Blackbutt or Ironbark in post-war builds. Each sands and finishes a bit differently — we identify what you’ve got before quoting the approach.

Yes — cupped, stained or swollen boards from moisture are common in low-set homes. Some sand out, some need replacing and blending in. We’ll tell you honestly which yours are before any work starts.

Yes — weathered decks in Bardon can be sanded back and re-coated or oiled with exterior-grade products. Quoted separately from interior floors.

Both. Single rooms carry a minimum job fee so the per-metre rate is higher, but we do plenty of one-room jobs — bedrooms after carpet removal are the classic.

Any time works, but drier winter months give the most predictable coating conditions. Summer humidity just means slightly longer drying between coats — we plan for it either way.

No — our Lagler machines run with Festool extraction that captures most of it at the source. You’ll find a light film in the work area rather than dust through the whole house, and we clean up properly before coating anyway, since a clean floor is the only way to get a clean finish.